|DodgeRam.info > TSB's > 08-08-94 Rev. A|
|Visit Geno's Garage
for Truck accessories.
Models: 1994 (BR) Ram Truck
1994 (BR) Ram Truck
1994 (XJ) Cherokee
Horn may sound weak or have an unpleasant tone on vehicles equipped with a single note horn.
Inspect the vehicle when loaded. If the vehicle is low in the rear, perform the repair procedure.
1 56007385 Horn and bracket assembly - BR
1 56007240 Horn and bracket assembly - XJ
1 34202608 Bolt - XJ
This bulletin involves upgrading a single note horn system to a dual note system.
1. Remove the existing horn and remove the screw from the hole in the bracket.
2. Install both horns with the brackets aligned opposing each other (the high note horn on the bottom) and tighten the screw.
The low note horn is located on the drivers side of the vehicle beneath the headlight. Locate the mounting bolt hole for the high note horn on the passenger side in the same general area as the low note horn. Install the horn and tighten the bolt to 21 Ft. lbs.
POLICY: Reimbursable within the provisions of the warranty.
Labor Operation No. 08-40-01-90 . . . . . . . . . . . . . . . . . . 0.2 Hrs.
FAILURE CODE: P8 - New Part
Thanks to Bob Bergevin and Barry Drodge for supplying this TSB information
This page was edited on: May 3, 2004