|DodgeRam.info > TSB's > 09-12-95|
|Visit Geno's Garage
for Truck accessories.
Date: Jun. 16, 1995
Models: 1995 (BR) Ram Truck
1995 (AB) Ram Van/Wagon
1995 (AN) Dakota/Dakota Cab & Chassis
1995 (BR) Ram Truck
1995 (ZJ) Grand Cherokee
NOTE: THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH 3.9L, 5.2L and 5.9L ENGINES.
The engine way exhibit excessively high oil pressure at cold start up. This may lead to distortion of the oil filter casing.
Inspect the oil filter case for any signs of distortion. If the case is distorted, perform the repair procedure. Connect an oil pressure gauge to the engine and start the engine while observing the readings. If the pressure reads above 80 psi, perform the repair procedure. This test must be performed with a cold engine. The vehicle mist be left over night to allow it to cool completely.
|1||53009295||Kit, Curb Height Lowering, 2500 Series 4X4 Ram Truck|
|1||53005646||Oil Pan Gasket (3.9L)|
|1||53005650||Oil Pan Gasket (5.2L)|
|1||53008610||Oil Pan Gasket (5.9L)|
This bulletin involves replacing the oil pump.
1. Using the procedures outlined in the appropriate Service Manual, replace the oil pump.
2 Replace the oil filter.
3. Add oil to the engine as required.
4. Start the engine and verify correct oil pressure.
Policy: Reimbursable within the provisions of the warranty.
|Labor Operation No:|
|09-65-01-92||Inspect Oil Filter||0.2 Hrs.|
|09-65-01-93||Oil Pressure Test (AB,AN,BR,ZJ)
|09-65-01-94||Oil Pump-Replace (AB)
Oil Pump-Replace (AN) 2WD
Oil Pump-Replace (BR) 2WD/4WD
Oil Pump-Replace (ZJ)
Skid Plate (ZJ)
Failure Code: P8 - New Part
Thanks to Barry Drodge for supplying this TSB information
This page was edited on: May 3, 2004