DodgeRam.info > TSB's > 08-30-99 > Page 2

TSB 08-30-99

Visit Geno's Garage for Truck accessories.

Page 2 of 4

9.     Remove the foam stuffer from the mirror-mounting opening.
10.   Remove the three nuts that secure the power mirror to the door panel.
11.   From the outside of the door, pull the mirror loose. As the mirror is being pulled from the door, feed the wire harness, grommet, and connector through the hole in the outer door panel.
12.   Remove the mirror-mounting gasket by peeling the gasket off the mounting bracket.
13.   Remove the three mounting bracket cover screws (Figure 5).

14. Rotate the mounting bracket cover approximately 180 degrees to expose the mirror's mounting clamp (Figure 6).

15.   Remove the four mounting bracket clamp retaining screws (Figure 6) and remove the clamp.

16.   Separate the mirror support arm from the mounting bracket assembly (Figure 7).

17.   Slide the friction sleeve off the support arm and wipe the arm and sleeve clean.
18.   Slide the friction sleeve back into place over the support arm.

TSB Summary           Third Page