| DodgeRam.info > TSB's > 08-058-05 |
TSB 08-058-05
Revised Radio Antenna Mast Installation Procedure
| Visit Geno's Garage for Truck accessories. |
 |
| DodgeRam.info > TSB's > 08-058-05 |
| Visit Geno's Garage for Truck accessories. |
|
Date: October 29, 2005
Models: 2005 - 2006 (DR/DH/D1) Ram Truck
2005 - 2006 (DR/DH/D1) Ram Truck
2005 - 2006 (HB) Durango
2005 - 2006 (ND) Dakota
2005 - 2006 (PL) Neon
2005 - 2006 (PT) PT Cruiser
2005 - 2006 (RS) Town & Country/Caravan
Discussion:
The installation procedure for the radio antenna mast has been revised. Please
use the
following procedure when installing the antenna mast to the antenna base.
CAUTION: Do not exceed the torque specification in the step below. Damage to
the
antenna mast and/or base may occur if the tightening torque is exceeded.
1. Install antenna mast to antenna base. Finger tighten the
antenna mast until it is fully
seated on antenna base; no gap between the mast and base. Using a torque wrench,
tighten the antenna mast to 3.4 - 3.6 N·m (30 - 32 in. lbs.) (Fig. 1).
Policy: Information Only
I would like to thank Bob Bergevin, Arthur Cantrall, Barry Drodge, David Lovell, Bill Maurits, and Steve for supplying the information for these bulletins. And a big thank you goes to Geno's Garage for making DodgeRam.info possible. |
This page was edited on: May 3, 2004