| DodgeRam.info > TSB's > 11-002-05 |
TSB 11-002-05
Vibration At Idle
| Visit Geno's Garage for Truck accessories. |
 |
| DodgeRam.info > TSB's > 11-002-05 |
| Visit Geno's Garage for Truck accessories. |
|
Date: September 17, 2005
Models: 2005 (DR/DH) Ram Truck
NOTE: This bulletin applies to vehicles equipped with 5.7L engines, sales code
EZA
and automatic transmissions.
Overview:
This bulletin involves installing a vibration damper on the exhaust system.
Symptom/Condition:
The vehicle may exhibit a vibration at idle, in gear. The vibration can be felt
in the seat and the
steering wheel.
Diagnosis:
If the vehicle exhibits the condition, perform the Repair Procedure.
Parts Required:
| Qty. | Part No. | Description |
| 1 | 52103612AA | Damper |
| 1 | 52019397 | Clamp |
Repair Procedure:
Allow the vehicle to sit long enough for the exhaust system to cool to a safe
temperature to
work on. Raise the vehicle on a hoist and install the damper on the front “Y”
pipe as shown.
Position the damper to provide adequate clearance to any nearby components.
(Fig. 1).
Tighten the clamp nuts to 42 Nm (31 ft. lbs.).
Policy: Reimbursable within the provisions of the warranty.
Time Allowance:
| Labor Operation No: | Description | Amount |
| 11-20-01-96 | Install Damper | 0.2 Hrs. |
Failure Code:
| ZZ | Service Bulletin |
I would like to thank Bob Bergevin, Arthur Cantrall, Barry Drodge, David Lovell, Bill Maurits, and Steve for supplying the information for these bulletins. And a big thank you goes to Geno's Garage for making DodgeRam.info possible. |
This page was edited on: May 3, 2004